Betekenis van:
factor of safety

factor of safety
Zelfstandig naamwoord
  • veiligheidsmarge
  • the ratio of the breaking stress of a structure to the estimated maximum stress in ordinary use

Synoniemen

Hyperoniemen


Voorbeeldzinnen

  1. Factor of safety
  2. Factor of safety — S
  3. S factor of safety
  4. Factor of safety S
  5. In the case of raw cane sugar, the sugar shall have a safety factor not exceeding 0,30.
  6. The rules and procedures of recognised organisations are a key factor for increasing safety and preventing accidents and pollution.
  7. Therefore, a detailed scientific analysis would be required to assess whether the current safety factor takes appropriate account of all relevant issues.
  8. Exceeding the basic conditions for adoption of the simplified measuring procedure: The ‘non-existence’ of a safety factor (λ ≥ 1,1 meaning that the evaluated results are at least 10 % off the safety-related limit values.
  9. In addition, an Overview of Process Hazard Analysis (PHA) and Hazard and Operability (HAZOP), principles of human factor, management of change, safety culture/employee participation will be covered at this workshop.
  10. The safety factor shall be determined by dividing the percentage moisture content of the sugar concerned by the difference between 100 and the degree of polarisation of that sugar.
  11. Semantic interoperability is an essential factor in achieving the benefits of electronic health records to improve the quality and safety of patient care, public health, clinical research, and health service management.
  12. As a result, nuclear security would be an enabling factor in the broader use of nuclear energy recognising the synergies between safety, security and safeguards recognising especially the principles of sustainability and efficiency.
  13. a safety factor not exceeding 0,45 when the degree of polarisation is 97 or above, or a moisture content not exceeding 1,4 % when the degree of polarisation is below 97.
  14. In addition to the criteria already identified, it is permissible to take the material elongation at failure into account in the selection of the safety factor defined in clause 3.4.3 of EN12663.
  15. Burst test: the purpose of the test is to provide evidence that the hydrogen container does not fail before a specified level of high pressure, the burst pressure (safety factor multiplied by the MAWP) is exceeded.